Monday, 26 January 2015

Authentic Innokin MVP 20w on Fasttech just £20.00

Authentic Innokin MVP 20w for just £20.00 on Fasttech. 

Available in green, white, black and silver.

  • 0.55 inch screen display wattage, voltage, battery level, resistant, puff counter, output current, vaping time
  • Variable Voltage: Voltage can be adjusted from 3.3 – 7.5 volts in .1 volt increments
  • Variable Wattage: Wattage can be adjusted from 6.0 – 20.0 watts in .5 watts increments
  • Battery level indicator: The battery capacity is displayed via green, yellow and red LED
    • Green = almost fully charged (when fully charged the LED light will power off)
    • Yellow = half power
    • Red = low power (required charge)
  • Press the power button three times in rapid to turn ON/OFF 
  • Puff counter: The integrated puff counter will record the number of puffs you have taken
  • Ohm meter: Reads the resistance of your atomizer/cartomizer/clearomizer
  • 10 seconds cut off
  • Low battery warning (lower than 3.3V)
  • Short-circuit/atomizer protection
  • Over-discharge protection
  • "Vape while charging" technology
  • Rememebers last voltage or wattage setting
  • Built-in 3 digit display: Digital display shows the ohms meter, voltage/wattage setting and the number of puffs taken since last time the battery was turned off
  • Portable power source for electronic products: Set the small pin switch on the bottom to "ON" position and connect a micro-USB cable to the USB OUTPUT port (DC 5V, maximum output current 0.5A)
  • "P" - power button: Variable wattage - VW
  • "U" - voltage button: Variable voltage - VV
  • Variable voltage mode: Press and hold the "U" button for 3 seconds to enter variable voltage mode
  • Variable wattage mode: Press and hold the "P" button for 3 seconds to enter variable wattage mode
  • Operating voltage: 3.3-7.5V
  • Operating wattage: 6.0-20W
  • Standby current: 100uA max
  • Maximum output wattage: 20W
  • Maximum output current: 6A
  • Maximum output voltage: 7.5V
  • Clearomizer resistance: 1.0ohm (minimum)
  • Charging: Micro-USB DC 5V/1000mA
  • Output port: DC 5V/1000mA


No comments:

Post a Comment